SPONSORS
2024 ICRBE EXPO |
Blank Identification
Posted by:
Steve Cox
(---.client.mchsi.com)
Date: February 21, 2011 02:23PM
I have a fly blank marked 'UTIF 905F' Do any of you know who made it? Re: Blank Identification
Posted by:
Bob Pratt
(---.cust.wildblue.net)
Date: February 21, 2011 02:33PM
Steve
I just did a quick Google search (rod blank UTIF 905F) and it might be an old Batson blank. Re: Blank Identification
Posted by:
Ken Finch
(---.orlando-04rh16rt.fl.dial-access.att.net)
Date: February 21, 2011 02:36PM
It would appear to at least be a 9' 5wt but no idea who might have made it. Re: Blank Identification
Posted by:
Bob Pratt
(12.189.32.---)
Date: February 21, 2011 02:52PM
From an other rod building site I found an old post that ID the IF as Batson's RX7 and the UTIF as a green RX7. From what I can gleam these are the numbers used when the RX7s were produced in the USA.
But I could be wrong. Bob Re: Blank Identification
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: February 21, 2011 02:58PM
Sounds like you should check with Batson. Re: Blank Identification
Posted by:
Grant Darby
(---.wavecable.com)
Date: February 21, 2011 04:59PM
You might want to give the folks at Utmost a jingle....UT = Utmost Re: Blank Identification
Posted by:
Walt Natzke
(170.146.227.---)
Date: February 21, 2011 06:12PM
Yep, Utmost...I have a couple of blanks from them with similar nomenclature. Walt Natzke Ripon, CA Re: Blank Identification
Posted by:
John Martines
(---.hsd1.pa.comcast.net)
Date: February 21, 2011 06:25PM
Sounds like an old Cascade Composites blank. Sorry, only registered users may post in this forum.
|