SPONSORS
2024 ICRBE EXPO |
Drill as Lathe
Posted by:
Nick Christou
(---.net.rss.rogers.com)
Date: January 26, 2011 12:13PM
Can someone please point me in the right direction.
I know I have seen it before...the direction on how to use a drill as a lathe. Thanks! Re: Drill as Lathe
Posted by:
Tom Kirkman
(Moderator)
Date: January 26, 2011 12:18PM
RodMaker Volume 6 #2 has the article on converting/using a drill press as a vertical lathe, including how to easily build the tailstock.
............ Re: Drill as Lathe
Posted by:
Herb Ladenheim
(---.mia.bellsouth.net)
Date: January 27, 2011 10:56PM
The Flexcoat cork late turns out some nice work. easier than do-it-yourself.
Herb Re: Drill as Lathe
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: January 28, 2011 07:46AM
if you get the Flex Coat one you could make up a channel set up so the lath slides onto it. Bill - willierods.com Sorry, only registered users may post in this forum.
|