SPONSORS
2024 ICRBE EXPO |
Rod spline--I made a mistake!!
Posted by:
Joe Camillo
(---.har.choiceone.net)
Date: January 06, 2011 11:09AM
I recently installed a new cork handle on one of my spinning rods. After the adhesive had set, I realized that I installed the handle upside down--that is, opposite the position it should have been in to take advantage of the power side of the rod spline. How bad of a mistake is this??
Thanks Re: Rod spline--I made a mistake!!
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: January 06, 2011 11:17AM
Most don't worry about the spine but just build on the straightest access of the blank. If it has a bend in it putting the bend pointing to the sky and putting the guides below on the curve. Bill - willierods.com Re: Rod spline--I made a mistake!!
Posted by:
Tom Kirkman
(Moderator)
Date: January 06, 2011 11:19AM
The softest and stiffest sides or axis of the blank are not 180 degrees opposite each other. In the long run, spine makes little to no difference. It's highly doubtful that you'll ever notice it.
On the other hand, if you feel it's going to be something that will mess with your head over the life and use of the rod, you can always shave the cork grip off and reinstall a new one. But before I did that I'd tape on some guides and go out and cast it a bit. I think you'll find that everything works just fine. ................ Re: Rod spline--I made a mistake!!
Posted by:
Joe Camillo
(---.har.choiceone.net)
Date: January 06, 2011 12:03PM
Actually my mistake is that I have the bend in the blank pointing toward the floor rather than toward the sky. Re: Rod spline--I made a mistake!!
Posted by:
Trinity Lindseth
(---.redlake.k12.mn.us)
Date: January 06, 2011 12:21PM
Does the rod tip point to the floor or up? If its to the floor you are good to go... Re: Rod spline--I made a mistake!!
Posted by:
Joe Camillo
(---.har.choiceone.net)
Date: January 06, 2011 12:45PM
The rod tip points toward the floor and I have not put the guide on yet. Re: Rod spline--I made a mistake!!
Posted by:
Tom Kirkman
(Moderator)
Date: January 06, 2011 12:53PM
Most prefer it pointing up, but it's still going to work fine.
.......... Re: Rod spline--I made a mistake!!
Posted by:
dave schaub
(---.scansafe.net)
Date: January 07, 2011 11:36AM
the short answer is NO PROBLEM. GO FISH. Re: Rod spline--I made a mistake!!
Posted by:
matthew jacobs
(---.234.22.98.dynamic.ip.windstream.net)
Date: January 08, 2011 12:27AM
Build it and rock out with it. Sorry, only registered users may post in this forum.
|