SPONSORS
2024 ICRBE EXPO |
First Micro Build
Posted by:
Jeffrey Janusonis
(---.dsl.mrdnct.sbcglobal.net)
Date: December 20, 2010 09:38AM
I am starting a carolina rig rod, I will be using micros probably 3.5 or 4 mm guides, I will be using braided line on this rig. I have a couple of questions. Should I use a locking wrap?. when a locking wrap is used do you still have enough play to move the guide slightly to align them?
Thanks Jeff Re: First Micro Build
Posted by:
Eric Green
(---.hsd1.tx.comcast.net)
Date: December 20, 2010 09:41AM
Good question - I'm building a T-rig rod right now also with 3 mm micros for flourocarbon. I was planning on using locking wraps and was assuming I would have enough play to adjust them prior to CP and finish. Re: First Micro Build
Posted by:
Steve Gardner
(---.nc.res.rr.com)
Date: December 20, 2010 09:44AM
I would recommend locking wraps. yes you will be able to move things around , however with a slight more difaculty. May have to wiggle them a little opposed to just pushing them over to center
With a C-rig I also suggest staying with a 6mm tip becasue of the tendency to reel the swivel up into it. Re: First Micro Build
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: December 20, 2010 02:08PM
I've just finished 2 rods with teh Forhan locking wrap, I guess thats what you are referring to, and yes i was able to move them to get them in line with the tip and the butt guides, at first I thought that i wouldn't be able to cause i wrappes them kinda tight, but it all turned out good, i was able to move them to get them in line with the others. Re: First Micro Build
Posted by:
justin keithley
(---.dhcp.aldl.mi.charter.com)
Date: December 20, 2010 07:00PM
yes on both counts.
i wrap pretty tight, so when adjusting the guides, i push on the eyelet with one hand and with the other hand also put pressure on the tip of the foot with my fingernail so the guide stays straight.. Pretty easy to adjust and they stay put once you get them there. Regards, -Justin Re: First Micro Build
Posted by:
Wes Christy
(---.rh1.dyn.cm.comporium.net)
Date: December 22, 2010 12:04AM
my only question is how to do the forhan knot. i have no idea! Re: First Micro Build
Posted by:
Robert A. Guist
(---.nmci.navy.mil)
Date: December 22, 2010 06:34AM
Hello All
Jeff Steve is right-on. Wes there is a tutorial on the lock wrap in the library. Everyone have a safe and happy Holiday! Bob, New Bern, NC. Sorry, only registered users may post in this forum.
|