SPONSORS
2024 ICRBE EXPO |
Blank suggestions
Posted by:
Brett Hinson
(---.nc.res.rr.com)
Date: October 17, 2010 01:43PM
I have a customer that wants a 5'6" to 6' spinning rod.. He wants it 4-8# ,1/16 to 5/16 oz. Must be 2 pc.
I havent been able to find one. Any suggestions? Edited 1 time(s). Last edit at 10/17/2010 01:53PM by Brett Hinson. Re: Blank suggestions
Posted by:
David von Doehren
(---.proxy.aol.com)
Date: October 17, 2010 04:00PM
Lamiglas internatioal series, graphite matte black, 5'6" IFW662L , 6' IFW722L . I've used them with good results.
Dave, PRRODS Edited 1 time(s). Last edit at 10/17/2010 05:50PM by Tom Kirkman. Re: Blank suggestions
Posted by:
Eugene Moore
(---.244.220.93.Dial1.StLouis1.Level3.net)
Date: October 17, 2010 04:28PM
Cabela's has 3 2-piece blanks in the cast weight range required but they are only rated up to 6#
St Croix has several 1-piece that you could ferrule into a 2-piece rod. You could also use the Cabela's 6' 2-piece PT 4 weight that should handle the job. Eugene Moore Re: Blank suggestions
Posted by:
George Forster
(---.hsd1.co.comcast.net)
Date: October 17, 2010 09:52PM
[www.schneidersrods.com] towards the bottom of the page
a 6' 4 piece or a 5'6' 2 piece might fit the bill if his specs aren't etched in stone George Forster Fort Collins, CO Re: Blank suggestions
Posted by:
Michael Danek
(---.proxy.aol.com)
Date: November 07, 2010 11:23PM
Make sure your customer really wants a short rod because he may not know how great an ultra light made from a 2 or 3 weight moderate action fly blank can be - 7 1/2 foot length/2 piece. Sorry, only registered users may post in this forum.
|