SPONSORS
2024 ICRBE EXPO |
removing epoxy
Posted by:
Mike Emerick
(---.sd.sd.cox.net)
Date: July 25, 2010 08:54AM
So I started to remove a tiger I didn't like and I have scraped the epoxy and thread off. Now I'm down to the last little bit. Do you keep scraping or is the another way to get back to the smooth blank Re: removing epoxy
Posted by:
Mike Emerick
(---.sd.sd.cox.net)
Date: July 25, 2010 08:57AM
sorry I just found another thread about using heat and wiping it off Re: removing epoxy
Posted by:
Raymond Adams
(---.hsd1.ca.comcast.net)
Date: July 25, 2010 08:59AM
Continue with scraping and if you need to warm the epoxy with a hair dryer or hot water to soften it.
That will loosen those stubborn bits. Raymond Adams Eventually, all things merge, and a river runs through it.. Sorry, only registered users may post in this forum.
|