SPONSORS
2024 ICRBE EXPO |
fighting butt cap
Posted by:
Anonymous User
(---.dhcp.stpt.wi.charter.com)
Date: July 02, 2010 06:41PM
i got 3 fighting butt cap here i was going to build a spinning rod very soon but i wonder how will u reamer the hole to fit on blank butt ? do u have to drill to get little more large diameter ? this cap i have doesnt have a double hole so i couldnt reamer to fit it's 350 ID on the butt cap, the blank butt is 385 ID, i'm goint to make as split grip handle like st. croix mojo style
any advice to get ID turn into little big to fit the blank butt.. Josh Re: fighting butt cap
Posted by:
Mike Winkler
(---.new.res.rr.com)
Date: July 02, 2010 06:47PM
Josh,
I use my cordless drill with a drill bit close to the size of the butt of the blanks diameter. I run the drill on reverse. Mike Re: fighting butt cap
Posted by:
Anonymous User
(---.dhcp.stpt.wi.charter.com)
Date: July 03, 2010 01:30PM
how about if i ever drill it to make little more large diametner then push it in blank butt before glue it ?? Sorry, only registered users may post in this forum.
|