SPONSORS
2024 ICRBE EXPO |
2.0 mm
Posted by:
Thomas Kaufmann
(---.hr.hr.cox.net)
Date: June 05, 2010 10:47AM
I have a quick question for those of you have used the 2.0 and 2.5 mm guides. Have you been transitioning from a typical 6,5,4,3 then all 2.5's or 2.0's or do you simply prefer to go from the 4 straight to the 2's or 2.5's??
Thanks and hop that you guys who were able to make the event today had a great time. Wish that I could have been there. Tom ' Re: 2.0 mm
Posted by:
Duane Richards
(---.ronkva.east.verizon.net)
Date: June 05, 2010 12:59PM
I like going from a 4 to a 3 and then to 2's as runners, slow spiral
DR Re: 2.0 mm
Posted by:
Steve Gardner
(---.nc.res.rr.com)
Date: June 06, 2010 06:58PM
Some times 6,5,4,3
and some times 5,4,3 and never 4 then 2.5 or 2mm Depending on application; I will start will 6mm double ft (for heavier stuff or rough clients). Lighter stuff I will start with 5mm single Re: 2.0 mm
Posted by:
Thomas Kaufmann
(---.hr.hr.cox.net)
Date: June 06, 2010 09:47PM
thanks guys as always you all are a lifesaver!!!
Steve hope that the misses is doing well and you have been able to hit the water a little, again the tips are GREATLY appreciated! Tom Sorry, only registered users may post in this forum.
|