SPONSORS
2024 ICRBE EXPO |
Builders in Australia??
Posted by:
Jim Kirby
(---.dllstx.dsl-w.verizon.net)
Date: March 07, 2010 05:04PM
I've been corresponding with a fisherman in Australia who's looking to buy some good casting/spinning rods. Shipping costs for low quantities of long one-piece rods from here to there preclude me satisfying his needs but I thought readers of this board might be able to help me out in contacting some good, reputable builders more local to him. He's prepped to try rods built on CTS blanks. If you can help me, drop me a line with a name, email address, and possibly a phone number I'll forward it on to him. I'm still kicking myself for not talking to the Aussie builder who attended the ICRBE but I know someone here will come through for me. Thanks, Jim Re: Builders in Australia??
Posted by:
Bobby Feazel
(---.140.184.173.dynamic.ip.windstream.net)
Date: March 07, 2010 05:51PM
My email address is visible.
Contact me and I will give you contact information of a good source. Bobby Feazel [www.shockwaverods.com] Conventional wisdom will not open the box. Re: Builders in Australia??
Posted by:
Clyde Alho
(---.dsl.emhril.sbcglobal.net)
Date: March 07, 2010 06:11PM
Hi Jim,
The Aussie rod builder and his father stopped by my booth at the ICRBE. He bought an EcoWrapper from me so if you would like, drop me an email at cralho@therodshop.biz and I will forward it to him so he can contact you. Hope this helps, Clyde Alho The Rod Shop, Inc. Re: Builders in Australia??
Posted by:
Dwight McCalla
(---.110.102.97.cfl.res.rr.com)
Date: March 08, 2010 12:19AM
[www.dakau.com.au]
Have your friend check this site out, the guy that runs it is named Rohit, and he makes really good rod, He also sponor a few guys in that bara circuit as well as take part in it.... but all in all he is a spectacular rod builder..... Re: Builders in Australia??
Posted by:
Charles Clayton
(---.ldcz2.ken.bigpond.net.au)
Date: March 08, 2010 02:48AM
Australia a big place, shipping from one side to the other could be the same as from the US, are you able to narrow down his location a bit. Re: Builders in Australia??
Posted by:
Jim Kirby
(---.dllstx.dsl-w.verizon.net)
Date: March 08, 2010 03:17AM
Charles, I believe he's in NSW. Re: Builders in Australia??
Posted by:
Stuart Klose
(---.lns20.per1.internode.on.net)
Date: March 08, 2010 05:57AM
Jim
Tell him to contact Gary Howard, he distributes both CTS and North Fork in Australia. Stuart Sorry, only registered users may post in this forum.
|