SPONSORS
2024 ICRBE EXPO |
Stuart Tuff Butt assembly
Posted by:
Clyde Hunt
(---.bltmmd.fios.verizon.net)
Date: February 12, 2010 02:52PM
I normally build from scratch but decided to give the Stuart Tuff Butt assemblies a try. Does anyone know what size gimbal they use in the assembly? I need to order an aluminum gimbal to replace the nylon one in the kit. Re: Stuart Tuff Butt assembly
Posted by:
Dennis Danku
(---.nwrknj.east.verizon.net)
Date: February 13, 2010 02:26AM
Clyde, I just measured the ones on hand, its 1.035. Hope this helps. Dennis Re: Stuart Tuff Butt assembly
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: February 13, 2010 08:06AM
call the supplier you got the butt from, he can look it up. Bill - willierods.com Re: Stuart Tuff Butt assembly
Posted by:
Chris Garrity
(---.phlapa.east.verizon.net)
Date: February 13, 2010 12:01PM
I just built a rod with a tuff butt for the first time, and I was tempted to do exactly what you're talking about. I ended up sticking with the vinyl, because it seemed plenty tough for how the rod would be used. But this is an easy one: just have your supplier match a gimbal for you. It should take about 30 seconds.
I think you're going to like how this turns out, by the way -- I've become a big fan of the Stuart Tuff Butt. They really make a nice trolling butt, without breaking the bank. Re: Stuart Tuff Butt assembly
Posted by:
Scott Parsons
(---.nc.res.rr.com)
Date: February 13, 2010 05:05PM
Clyde, In the tuff butts that I have built and sell the size 27 matches up to the bottom od just right, if you want to use the rounded ring provided then you can go with any size you would like. Thanks Sorry, only registered users may post in this forum.
|