SPONSORS
2024 ICRBE EXPO |
Decal problems
Posted by:
Mike Winkler
(---.samuelmanutech.com)
Date: December 29, 2009 07:06AM
I just finished a theme based ice fishing rod for a buddy. Due to the small diameter of the blank I was having a heck of a time getting edges of the decal to stick. After 4 decals trying all sorts of ideas pulled off of this site, and lots of adverbs and adjectives being mumbled I finally got it.
I took 2lbs test mono and did a spiral wrap around the decal. The I think I only had about 4 wraps around the entire decal. But it was enough to pull the edges. I then epoxied over the entire thing. That was the ticket. Edges are down and you can not see the mono. It might work even better if you used some small diameter fly tippet. Just an idea for some one who might have an issue with a decals edges lifting. Re: Decal problems
Posted by:
Jimi Ellis
(---.hsd1.ga.comcast.net)
Date: December 30, 2009 07:57AM
Mike,
Check your email Jimi Ellis Southern Grafix www.SouthernGrafix.com Sorry, only registered users may post in this forum.
|