SPONSORS
2024 ICRBE EXPO |
Need info on graphite rod please.
Posted by:
Danny Condruti
(---.pools.spcsdns.net)
Date: December 22, 2009 09:45PM
I have a few graphite blanks from a few co. and all are dark gray with wave ribbs (like a earthworm...) when in the sun. In stores I have seen rods (ready made) from Abu and Okuma that are IM-8 graphite but the rods are dull jet black in color, not dark gray. Can some body tell me the difference please and where I can find the black blanks? Thank you. Please keep the internet green! Recycle electrons. Re: Need info on graphite rod please.
Posted by:
J.B. Hunt
(---.pool.dsl.logantele.com)
Date: December 22, 2009 10:55PM
Most of the Sponsors on the left sell both the flat black and the clear graphite. The clear graphite blanks have not been painted, the black ones have. The blanks you have that have ribs like an earth worm have not been painted, maybe just clear coat , if they are shiny. Below is a photo of one called a Seeker that is clear graphite in the butt section and painted glossy black in the tip section. A powerful blank that has ribs like a starving dog !
[www.rodbuilding.org] Re: Need info on graphite rod please.
Posted by:
Danny Condruti
(---.pools.spcsdns.net)
Date: December 23, 2009 03:13AM
Thanks for the info, did not know about the paint job.
I have the Seeker CJB90F with black E-glass on top. Have looked at the sponsors on the left but had a hard time finding a flat black, 100% graphite blanks. Any guidance is appreciated. Thanks. Please keep the internet green! Recycle electrons. Re: Need info on graphite rod please.
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: December 23, 2009 07:15AM
I've bought graphite blanks in a matt black finish similar to what was popular in the G Loomis GL3 blanks from Angler's Workshop over the years. Swampland has some matt black Castaway blanks also I think. Edited 1 time(s). Last edit at 12/23/2009 08:11AM by Spencer Phipps. Re: Need info on graphite rod please.
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: December 23, 2009 08:28AM
Also Lamiglass and I think St Croix has them. Probably others Look around, try mud hole. Bill - willierods.com Re: Need info on graphite rod please.
Posted by:
Edwin Kime
(---.dsl.wchtks.sbcglobal.net)
Date: December 23, 2009 08:31AM
I have gotten some flat black blanks from Lamglas in the International Fresh Water series from Mudhole but many others on the left also carry them.
Edwin Kime Re: Need info on graphite rod please.
Posted by:
Joe Vanfossen
(---.neo.res.rr.com)
Date: December 23, 2009 08:47AM
Batson RX8+ bass blanks.
Joe Sorry, only registered users may post in this forum.
|