SPONSORS
2024 ICRBE EXPO |
boring reel seat
Posted by:
Thomas Kaufmann
(---.t1.cavtel.net)
Date: October 10, 2009 09:59AM
Morning guys,
What are you all using to bore out the graphite type of casting seats (ecsm and the like)? Will the spade bits work or do you have something better that you would recommend. thanks, Tom Re: boring reel seat
Posted by:
Aaron Cavanaugh
(---.hsd1.mn.comcast.net)
Date: October 10, 2009 10:06AM
I used the Batson Forecast Dream Weaver and put mild pressure on it. Didn't hurt the sand papery stuff, and it did a good job on the seat.
Hope you're well, Tom. AC FishinFreaks Rogers, MN Re: boring reel seat
Posted by:
J.B. Hunt
(---.ppoe.dsl.logantele.com)
Date: October 10, 2009 10:19AM
I use the Forcast Reamers plus some I made also. J.B.Hunt Bowling Green, KY Re: boring reel seat
Posted by:
Thomas Kaufmann
(---.hr.hr.cox.net)
Date: October 12, 2009 08:36AM
Thanks guys,
I have been using reamers as well but I think that I might be putting a little too much speed to them.... ate them up pretty badly. Re: boring reel seat
Posted by:
Scott Throop
(---.dsl.irvnca.sbcglobal.net)
Date: October 13, 2009 12:21AM
I thought this post was about a really bland reelseat..:P Sorry, only registered users may post in this forum.
|