SPONSORS
2024 ICRBE EXPO |
New here
Posted by:
Jeff Bernier
(---.lightspeed.irvnca.sbcglobal.net)
Date: August 07, 2009 03:03PM
Hay new to the board looking forward to learning alot thanks everyone.
Jeff Re: New here
Posted by:
ed barron
(---.altnpa.east.verizon.net)
Date: August 07, 2009 03:09PM
jeff iam also a new comer but been around long enough to tell you this is the best rod building page and group of people you can find becareful though it is very addictive once you start reading you cant stop thires some great stuff here Re: New here
Posted by:
William Bartlett
(---.br1.dav.wv.frontiernet.net)
Date: August 07, 2009 03:17PM
Welcome abourd guys!! Enjoy!!!!! Bill in WV Re: New here
Posted by:
Ricardo Morais
(200.185.128.---)
Date: August 07, 2009 04:20PM
Ether me brothers....
Justing reading all msgs and learning a lot. I'm from Brazil and here, there are a few rodbuilder that don't share any info... So Rodbuilding.org is a primary resource. Regards Rick Morais Brazil Re: New here
Posted by:
Kyle Robinson
(---.proxy.aol.com)
Date: August 07, 2009 04:56PM
Jeff, I have only been around a few months myself. These folks are great. Not only are they helpfull, and willing to share info, they try to share the correct ways to do stuff, not just @#$%& you.
If you have a question, you can pm them for the answers also...great folks! The sponsors to the left are great sources for info. I have been on a lot of forums, finally decided this was the best one to be active on. Get hooked up with the RodMaker Magazine also. Tom has put together the best info available there also. Kyle Robinson Re: New here
Posted by:
Jeff Bernier
(---.lightspeed.irvnca.sbcglobal.net)
Date: August 10, 2009 12:25AM
Thanks every one for the warm welcome, I have been wrapping meny years, took a long break and have now found my way back. I have made a few buck over the summer so far repairing some rods and have had some requests for custom jobs as well. I will be hanging out here mre often tring to perfect my craft, don't think I will be aas good as some but I will try to get better in time.
My next goal is the Tiger Wrap, I was kind of caught off gaurd when some one asked can I do this. I said I will need to look into it and get back to you. Thank goodness for the Rodmaker Magazine there online PDF file was just the ticket. Does anyone know if there are any other PDF Files I could get a hold of until my subscription comes through. Thanks Jeff Re: New here
Posted by:
William Bartlett
(---.proxy.aol.com)
Date: August 11, 2009 01:33AM
Tom will have to answer the RodMaker PDF question, but here is a link to a site you need to go to and bookmark for tons of How-To's [rodbuildingtutorials.com]
Again WELCOME to the ADDICTION, and ENJOY!!! Bill in WV Re: New here
Posted by:
Jeff Bernier
(---.dc.rr.com)
Date: August 11, 2009 09:04PM
William Bartlett Wrote:
------------------------------------------------------- > Tom will have to answer the RodMaker PDF question, > but here is a link to a site you need to go to > and bookmark for tons of How-To's > [rodbuildingtutorials.com] > > Again WELCOME to the ADDICTION, and ENJOY!!! Thanks I headed over and I am very impressd with what is there, what a place to learn thank you very much for the direction Sorry, only registered users may post in this forum.
|