SPONSORS
2024 ICRBE EXPO |
Guides and handle
Posted by:
Jerry Hirsch
(---.neo.res.rr.com)
Date: July 25, 2009 02:45PM
Hi,
I would like to ask you couple questions. I bought 2 rainshadow blanks and I am looking for guides and handle lenght. I will built them as a spinning rods. 1; live bait RCLB L 15-30lb( handle lenght, type of guides and size).(20lb braid) 2;popping IP904F 8-17lb ( I would like to use micro guides as a running guides).(10lb braid) I am asking because I don't have any expirience with saltwater rods. Thank you for your help Jerry Re: Guides and handle
Posted by:
Steve Gardner
(---.nc.res.rr.com)
Date: July 25, 2009 02:57PM
Here are a couple of stating points from Batson’s web Site
[www.batsonenterprises.com] [www.batsonenterprises.com] Re: Guides and handle
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: July 25, 2009 05:23PM
What reels are you using? Re: Guides and handle
Posted by:
Jerry Hirsch
(---.neo.res.rr.com)
Date: July 25, 2009 06:09PM
I will use Catalyst PTS(30 or 40) for popping rod and Shimano Spheros(5000) for RCLB blank.
Steve: I checked the guides on Batson website but for RCLB blank there is no guide type or spacing for spinning rods only casting. Thank you!! Edited 1 time(s). Last edit at 07/25/2009 06:13PM by Jerry Hirsch. Re: Guides and handle
Posted by:
Chuck Howard
(---.carolina.res.rr.com)
Date: July 25, 2009 06:22PM
In racing, being copied is the ultimate form of flattery; it is also a good way to allow others to test new waters for you. My point is that everyone watches what everone else does. I look at what I like in retail poles I own and what I dislike. I cast my friends poles and look at the different nuances in poles at the stores or rod shows. Just like race cars -fishing poles are in some form handmade and therefore individual little snow flakes. The same can be said of race car drivers -I can take a car and sit on the pole with it, and another driver can get into it and want to crush it and start all over.
Enjoy the ride and remember, the worst pole I ever made is the best handle reamer I own! Build rods, experiment, and cite you inspiration; helps the new guys like us, and thanks the old guys for giving back to what they love. Re: Guides and handle
Posted by:
Jerry Hirsch
(---.neo.res.rr.com)
Date: July 25, 2009 08:29PM
Hi,
can I use spinning guides(Batson VS3 or Fuji BYAG) with RCLB 15-30lb or should I use something else. Thank you!!! Re: Guides and handle
Posted by:
Bob Balcombe
(207.118.63.---)
Date: July 26, 2009 11:29PM
Basically it is up to you. I would call Karry Batson and get his opinion. Then call Todd Vivian at Mud hole and get his thoughts.Then go to a supplier and get their opinion. You well find no one will have the same answer. The same goes for this site or and other site Good Wraps Bob Re: Guides and handle
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: July 27, 2009 11:40AM
For starting points try St Croix's site and Fuji. Bill - willierods.com Sorry, only registered users may post in this forum.
|