SPONSORS
2024 ICRBE EXPO |
paint a blank
Posted by:
cosimo-angione
(---.45-79-r.retail.telecomitalia.it)
Date: June 14, 2009 03:24AM
I would like to know how to paint with permagloss (or possible other products) my carbon rod.
Particularly how to apply on the whole blanck. You forgive out by now my English. Thanks a lot for every suggestions..... Re: paint a blank
Posted by:
Tom Kirkman
(Moderator)
Date: June 14, 2009 05:35AM
The best way I have found is to wet a piece of cheesecloth and then make a quick swipe, butt to tip (or vice versa) down one side and then the other. Wait 20 to 30 minutes and repeat. This gives me a better finish than brushing.
.................. Re: paint a blank
Posted by:
cosimo-angione
(---.46-79-r.retail.telecomitalia.it)
Date: June 15, 2009 02:32PM
Thanks a lot Tom!
Can you explain me whath is "cheescloth"? Someone said me to use a spray gun...what do you think about these technique? Re: paint a blank
Posted by:
C. Royce Harrelson
(---.proxy.aol.com)
Date: June 15, 2009 05:17PM
Cheesecloth is a net like material commanly used in cheese making for draining. I think that it is called mussolina in Italy. Re: paint a blank
Posted by:
bill boettcher
(---.sttl.mdsg-pacwest.com)
Date: June 15, 2009 06:45PM
I have used the cheese cloth but then tried and like better the black sponge of the paint brushes found at Home Depot. Bill - willierods.com Re: paint a blank
Posted by:
cosimo-angione
(---.46-79-r.retail.telecomitalia.it)
Date: June 16, 2009 01:05AM
Thanks again for your suggestions!
I'll try and then I'll make you know. Sorry, only registered users may post in this forum.
|