SPONSORS
2024 ICRBE EXPO |
new member with ?
Posted by:
don martin
(---.dr01.blfd.wv.frontiernet.net)
Date: June 11, 2009 10:56AM
hi every one ,working on my third rod now doing a butt wrap is color presever applied to the wrap before your tie off ends. as i had finished the first wrap and when i tied off the ends my threads came loose and i had to cut the wrap off the rod . most of my question are answered by doing a search .what a great web site Re: new member with ?
Posted by:
Tom Kirkman
(Moderator)
Date: June 11, 2009 11:05AM
Good background information always helps.
You can apply CP before you tie off, if you like. But your problem is most easily solved by the proper tie-off procedure. Begin your tie-off wrap - make it very snug. Wind over the wrap end a good dozen turns or so, and then begin snipping your pattern threads. Don't cut them all at once or you'll have a lump under your tie-off wrap. Snip a few and then make another wrap or two with your tie-off thread. Then snip a few more. Then make another couple turns with your tie-off thread. Continue this until all the pattern threads have been cut. But always make that first dozen or so turns, snugly, with your tie-off thread before cutting any of the pattern threads. .............. Re: new member with ?
Posted by:
bill boettcher
(---.mis.prserv.net)
Date: June 11, 2009 11:24AM
Tom:
There was a tutorial on end wraps buy Billy V. I could not find it. Do you have a link for him. HERE Don I found it: [visualweave.com] Bill - willierods.com Edited 2 time(s). Last edit at 06/11/2009 11:33AM by bill boettcher. Re: new member with ?
Posted by:
don martin
(---.dr01.blfd.wv.frontiernet.net)
Date: June 11, 2009 02:00PM
Thanks for the reply tom and the link Bill you guys have been a great help . Sorry, only registered users may post in this forum.
|