SPONSORS
2024 ICRBE EXPO |
Looking for a small dia aluminum rod tube.
Posted by:
Ray Cover
(---.dsl.stlsmo.swbell.net)
Date: May 17, 2009 11:16PM
Do any of you know where I can find a small Dia aluminum rod tube?
The 2" tubes seem to be the standard now days. This 2pc fly rod I just finished it a delicate little thing built on a Batson 6'6" 2wt blank . I would like to find a 1 1/2" dia rod tube 42" long if I can. I plan ot customize the tube a bit with leather covering and engraving on the end caps. A 2" tube just looks out of proportion and bulky for this rod. Thanks, Ray Re: Looking for a small dia aluminum rod tube.
Posted by:
Jim Gamble
(---.187-72.tampabay.res.rr.com)
Date: May 17, 2009 11:19PM Re: Looking for a small dia aluminum rod tube.
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: May 18, 2009 08:51AM
They will also cut to non-standard lengths for a small fee, just give them a call.
Terry Re: Looking for a small dia aluminum rod tube.
Posted by:
Bill Moschler
(---.hsd1.tn.comcast.net)
Date: May 18, 2009 03:27PM
REC has the one and five eights tubs also. They will cut to length. I am pretty sure Custom tackle with have it in the Landmarfk aluminum tubes also.
I have not found a industrial source of tubing that looked good for rod building in other sizes. Edited 1 time(s). Last edit at 05/18/2009 03:29PM by Bill Moschler. Re: Looking for a small dia aluminum rod tube.
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: May 18, 2009 09:44PM
Ray,
Another very nice and good option is to use a piece of thin wall pvc tubing and make a tight fitting nylon cover for the outside. Very inexpensive, but very attractive. Roger Re: Looking for a small dia aluminum rod tube.
Posted by:
Ray Cover
(---.dsl.stlsmo.swbell.net)
Date: May 18, 2009 10:06PM
Some one emailed me the link to the Landmark website. I like the look of their tubes with the domed brass caps. Very classy and very attractive. I think thats the way I will end up going.
Thanks guys, Ray Sorry, only registered users may post in this forum.
|