SPONSORS
2024 ICRBE EXPO |
Mixing TM's
Posted by:
Steve Cox
(---.client.mchsi.com)
Date: April 01, 2009 01:23AM
Thought I had an extra stash of ThreadMaster regular. Discovered it was another brand. I have several rods to finish in the next few days and I am rather low on Regular TM.... but I do have most of a set of TM Lite left. Have any of you mixed approximate equal portions of TM Lite with TM Reg? What results did you get? I certainly can experiment but if that goes south I have used up what little Regular I have left. I will order more tomorrow but I may have to do yard work when I could be building rods. Thanks Re: Mixing TM's
Posted by:
Robert Balcombe
(---.dyn.centurytel.net)
Date: April 01, 2009 03:10AM
This would be a question you should ask TM about Good Wraps Bob Re: Mixing TM's
Posted by:
Scott Parsons
(205.244.119.---)
Date: April 01, 2009 08:16AM
Steve, I will have to get with my Chemist and ask him and I will do so today. But why don't you just do multiple coats of the lite? I know it takes more time but you can get the same results. I will try to get back to you later this afternoon. Thanks for using our finish. Scott Parsons Re: Mixing TM's
Posted by:
Billy Vivona
(---.nycmny.east.verizon.net)
Date: April 01, 2009 08:16AM
IT takes 5 minutes to experiment, and you don't have to worry abotu a bogus answer.
FWIW, I mix Aftcote and Threadmaster on every rod I build. Sorry, only registered users may post in this forum.
|