SPONSORS
2024 ICRBE EXPO |
Madeira without CP
Posted by:
Andy Jones
(---.gsp.bellsouth.net)
Date: January 05, 2009 08:01PM
Has anyone used Madeira polyneon thread without CP without getting fisheyes? I know that there is a silicone lubricant on it. What if the finished wrap was cleaned with denatured alcohol to remove the silicone? Re: Madeira without CP
Posted by:
Jim Rippe
(---.chcgilgm.dynamic.covad.net)
Date: January 05, 2009 08:15PM
Here are two wraps I have done with Madeira, Polyneon #40 with no CP. I have had no problem with fisheyes. After talking to others it seems the fisheye do appear if they use heat or flame on the epoxy.
[www.rodbuilding.org] [www.rodbuilding.org] Re: Madeira without CP
Posted by:
John Martines
(---.proxy.aol.com)
Date: January 05, 2009 08:33PM
I had a problem where when I put epoxy to the thread it went clear on me but only in certain spots. The metallic Sulky and such I never have problems with. Re: Madeira without CP
Posted by:
Fred Yarmolowicz
(---.hsd1.nj.comcast.net)
Date: January 05, 2009 09:43PM
I have also had good luck using the Diamondite by Swifty finish. It is a little different than the others as it started life as an adhesive. Freddwhy (Rapt-Ryte) Re: Madeira without CP
Posted by:
Sean Endres
(---.cpe.metrocast.net)
Date: January 05, 2009 10:22PM
Just finished another Madeira wrap yesterday, no CP, no problems. I have been doing it a lot lately. Sean Endres North East Rod Builders New London, CT Edited 1 time(s). Last edit at 01/06/2009 12:08AM by Sean Endres. Sorry, only registered users may post in this forum.
|