SPONSORS
2024 ICRBE EXPO |
1st Rod Wrap
Posted by:
Ron Fletcher
(---.dsl.pltn13.pacbell.net)
Date: January 03, 2009 08:18PM
This is my 1st post and I just finished my 1st rod. I have been reading your forum for the last month or two. Thanks for all of the good info. I posted pictures in the Guide and Thread Art. Edited 2 time(s). Last edit at 01/03/2009 08:21PM by Ron Fletcher. Re: 1st Rod Wrap
Posted by:
Raymond Adams
(---.hsd1.ca.comcast.net)
Date: January 03, 2009 09:50PM
Well done Ron,
A nice crosswrap on the first build is a bit adventuresome and ya pulled it off quite well. Got some minor thread gapping on the guide you posted but they will get better & easier. The camera sees EVERYTHING! Do you have a good set of magnifiers? Raymond Adams Eventually, all things merge, and a river runs through it.. Re: 1st Rod Wrap
Posted by:
Ron Fletcher
(---.dsl.pltn13.pacbell.net)
Date: January 04, 2009 12:11AM
Thanks your not kidding about what the camera sees. I noticed that after I took the pictures and then when I brought it outside after the finish coat. I am trying to figure out how I want to do the next one. No I do not have any magnifiers and I need better light. I put two coats thinned 50% and 1 coat 100% CP (Flex Coat) on the guides and I just hope that they hold up. Then I finished it with Flex Coat High build. Re: 1st Rod Wrap
Posted by:
Raymond Adams
(---.hsd1.ca.comcast.net)
Date: January 04, 2009 01:04AM
Don't worry about them holding up. They will be fine. My first few rods were not near as good!
Magifiers are not near as helpful as good lighting but even bright young eyes will be surprised when one uses them. Especially after one takes a few photos! You should be proud now but wait till ya land a nice one with that rod. Raymond Adams Eventually, all things merge, and a river runs through it.. Sorry, only registered users may post in this forum.
|