SPONSORS
2024 ICRBE EXPO |
Used parts
Posted by:
Kenneth Prager
(208.248.9.---)
Date: November 13, 2002 11:32AM
I want to utilize some "used" parts - a reel seat and a cork handle in an effort to keep building while I wait for an order to arrive. These parts still have the old rod blank segment inside them. If I find a blank that has the proper OD and approximate taper can I build the rod just like the used parts were new. How should I prep the inside surface of the rod blank pieces that are epoxied inside the reel seat and cork grip. Any advise would save a bad experience trying it on my own. Re: Used parts
Posted by:
Bill Boettcher
(---.cvx.algx.net)
Date: November 13, 2002 12:02PM
I clean mine out with a drill and rat tail files - ( carefully ) Don't try to get it all out in one shot, a little at a time Hope this helps Re: Used parts
Posted by:
Bill Boettcher
(---.cvx.algx.net)
Date: November 13, 2002 12:04PM
Just another thought - boiling might help. May help to lossen the epoxie Sorry, only registered users may post in this forum.
|