SPONSORS
2024 ICRBE EXPO |
Engraving
Posted by:
Vern Metcalf Jr
(---.mn.warpdriveonline.com)
Date: November 30, 2008 07:54PM
Anyone ever tried engraving witha dremel tool on a blank itself???I know you would have to keep a constant depth but just curious if anyone has tried it and the results.
Thanks Re: Engraving
Posted by:
Tom Kirkman
(Moderator)
Date: November 30, 2008 08:07PM
Unless you have a very heavy walled blank and confined your engraving to the extreme butt, you would be destroying the blank.
Modern graphite blanks are made with very little margin for error - engraving into the surface of the blank is a recipe for disaster. ................... Re: Engraving
Posted by:
Vern Metcalf Jr
(---.mn.warpdriveonline.com)
Date: November 30, 2008 08:13PM
thanks Tom, Based on that , I wont even try it. Re: Engraving
Posted by:
Matt White
(---.den1.dsl.speakeasy.net)
Date: December 01, 2008 12:04PM
I would give it a shot on the reel seat or the handle. Matt White Sorry, only registered users may post in this forum.
|