SPONSORS
2024 ICRBE EXPO |
ThreadMaster on the site
Posted by:
Scott Parsons
(---.nc.res.rr.com)
Date: July 25, 2008 07:40PM
Hello everyone I have just finished uploading The ThreadMaster line of products to my web site. High Build, Lite, ChromaSeal, Ultimate Gel 5 and 15min as well as the Syringes. Thanks for looking and all of your support. More goodies to come soon www.scottscustomrods.com Scott Parsons Re: ThreadMaster on the site
Posted by:
Mike Adams
(71.80.150.---)
Date: July 26, 2008 01:54AM
Hi Scott, been looking at your urethane foam mixer and wondering how you clean it after use? Spray with mold release prior to use or some other trick? I've been using large spatulas purchased from the Dollar Store. After the foam dries it flakes off rather easily and they seem to mix the liquid OK but I'm alway looking for something better. Re: ThreadMaster on the site
Posted by:
Scott Parsons
(---.nc.res.rr.com)
Date: July 26, 2008 10:29AM
Mike, Right after you mix the foam pour it into your mold and then take the mixer out of the drill and wash it with water. If you are using 1 of my molds you would wash off the mixer before you would seal the mold shut. In high Point I just had a bowl of water there with me and rinsed it in that. Thanks for looking at the site. Scott Parsons www.scottscustomrods.com Re: ThreadMaster on the site
Posted by:
allen forsdyke
(---.colc.cable.ntl.com)
Date: July 26, 2008 02:28PM
i used the wifes kitchen blender then denied all knoledge of it blaming the kids
Didnt work now i been banned from using the kitchen equipment unless the wife is watching Sorry, only registered users may post in this forum.
|