SPONSORS
2024 ICRBE EXPO |
Solid Black EVA Ring
Posted by:
Aaron Cavanaugh
(---.mn.warpdriveonline.com)
Date: May 07, 2008 02:23PM
A couple years ago, I bought a couple 1 3/8 or 1 1/2 inch EVA discs that I used as a butt piece on a couple rods. I'm looking for those again as I don't like the slide on rounded butts you get for EVA grips. I haven't been able to find them and was hoping that someone could steer me to them.
Thanks! AC FishinFreaks Rogers, MN Re: Solid Black EVA Ring
Posted by:
Robert Tignor
(---.hsd1.va.comcast.net)
Date: May 07, 2008 02:54PM
Aaron , we have them ,but not on our webstie yet . Eva foam butt disc 9/16"x13/8" Flexcoat part # FBD . If you call , please call the office number Robert Re: Solid Black EVA Ring
Posted by:
Aaron Cavanaugh
(---.mn.warpdriveonline.com)
Date: May 07, 2008 03:01PM
Excellent. Thanks Robert. AC FishinFreaks Rogers, MN Re: Solid Black EVA Ring
Posted by:
Ted Morgan
(---.qld.bigpond.net.au)
Date: May 07, 2008 06:19PM
Another way to close off an EVA grip, which works best with small diameter blanks, is to install the grip with an overhang off the end of the blank, using a slightly longer grip. Then just plug the hole, like with a cork pistol grip, with a small disc of EVA and contact cement. The EVA disc, depending on size, can be cut from scrap or old grip material. Re: Solid Black EVA Ring
Posted by:
J.B. Hunt
(---.dsl.logantele.com)
Date: May 07, 2008 08:47PM
I do it like Ted on the smaller blanks. Extend the grip out a little and plug it. Looks like it was born that way. J.B.Hunt Bowling Green, KY Re: Solid Black EVA Ring
Posted by:
Aaron Cavanaugh
(---.mn.warpdriveonline.com)
Date: May 07, 2008 09:20PM
Ted Morgan Wrote:
------------------------------------------------------- > Another way to close off an EVA grip, which works > best with small diameter blanks, is to install the > grip with an overhang off the end of the blank, > using a slightly longer grip. Then just plug the > hole, like with a cork pistol grip, with a small > disc of EVA and contact cement. The EVA disc, > depending on size, can be cut from scrap or old > grip material. Seems like a good option. Maybe on my next EVA handle. Too late on my current. Oh well. AC FishinFreaks Rogers, MN Re: Solid Black EVA Ring
Posted by:
Thomas Kaufmann
(---.nmci.navy.mil)
Date: May 08, 2008 10:25AM
Aaron, give Bob a call at Custom Tackle that is where I got the last ones I purchased. Sorry, only registered users may post in this forum.
|