SPONSORS
2024 ICRBE EXPO |
Fuji BUNAG guide heights?
Posted by:
Luis Morales
(---.wor.ma.conversent.net)
Date: January 09, 2008 10:29AM
I checked the fuji tackle web site and couldn't find the specs on the BUNAG bridge guides. Does anyone have them? I was thinking of using them as running guides on a GSB 1081L.
Thanks Luis Re: Fuji BUNAG guide heights?
Posted by:
Marty Martin
(---.gsp.bellsouth.net)
Date: January 09, 2008 11:09AM
I remember finding a site with that info years ago, but I also seem to remember no height difference between the "bridge" guide and a regular spinning guide in the size 8 ring. If you are setting this rod up spinning, which I seem to remember you are, then I would use the fly guides - BFAG in the alconites or BFLG in the Batson I believe. They will be lighter and do everything else just as well. Re: Fuji BUNAG guide heights?
Posted by:
Mike Barkley
(---.try.wideopenwest.com)
Date: January 09, 2008 12:02PM
I would go with the alconite fly guides also BLAG or the Batson fly's Mike (Southgate, MI) If I don't want to, I don't have to and nobody can make me (except my wife) cuz I'm RETIRED!! Re: Fuji BUNAG guide heights?
Posted by:
Mark Griffin
(---.lsanca.dsl-w.verizon.net)
Date: January 09, 2008 02:21PM
I assume you're looking for overall height?
BUNAG7J = .354" / 9.0mm BUNAG8J = .464" / 11.8mm If you're after a different measurement, just yell. Be happy to check it for you. Mark Griffin [] C&M Custom Tackle San Dimas, California Re: Fuji BUNAG guide heights?
Posted by:
Luis Morales
(---.wor.ma.conversent.net)
Date: January 09, 2008 04:52PM
Yes Mark, was looking for overall height on the BUNAG's and was considering these because they look stronger than the BLAG's and BYAG's.
Thank You everyone Re: Fuji BUNAG guide heights?
Posted by:
Marty Martin
(---.gsp.bellsouth.net)
Date: January 10, 2008 08:10AM
They will be no stronger than BLAGs, but if you like them they will work fine. Re: Fuji BUNAG guide heights?
Posted by:
Andrew Grant
(---.lwhe.2wcm.comporium.net)
Date: January 31, 2008 06:14PM
Sorry for bringing this back from the dead, but do you happen to have the heights of BYAG-8JL, BYAG-8, and BLAG-8. I am building a spinning rod with a 25, 16, and 10 BYAG guides and trying to figure out the best transition guide to go from Y guides to fly guides on out to the tip. Do you guys have a preference, or do you go straight to fly guides? Thanks. Sorry, only registered users may post in this forum.
|