SPONSORS
2024 ICRBE EXPO |
Cork Handle Bore
Posted by:
Richard Hahn
(199.173.224.---)
Date: October 09, 2007 01:40PM
Has anyone heard of a tool for boring out cork handles. It is a spade bit the has the sides sharpened and used on a drill in reverse and has an extention ..........
Does anyone know where I can buy one? It allows you to start the bit on the far end and pull toward you ......... the shaft and extention make a great guide and pulling it back would seem to keep the bit straighter .......... I saw one but I don't know where to get one ........ Re: Cork Handle Bore
Posted by:
Dave Gilberg
(---.pghk.east.verizon.net)
Date: October 09, 2007 02:00PM
Flex Coat Concept Reverse Pilot Bit
Mudhole has them as do other of the sponsors. Dave Re: Cork Handle Bore
Posted by:
Richard Hahn
(199.173.226.---)
Date: October 09, 2007 03:35PM
Thanks Re: Cork Handle Bore
Posted by:
Chris Beverley
(218.185.73.---)
Date: October 09, 2007 07:01PM
Richard,
I just received mine and used it on several cork tubes. They work a treat!! Yo ned to be careful though.. they are not the easiest tings to use. Make sure you follow the instructions regarding the tape bushings. Re: Cork Handle Bore
Posted by:
Richard Hahn
(199.173.226.---)
Date: October 10, 2007 11:18AM
Thanks Guys ......... I ordered the 1/2 " and 5/8" yesterday from Mudhole .......... I also received rod handles, reel seats and foregrips yesterday ........ looks like I've got a lot to learn and figureout about fitting the handles to the rod and how to give the handle a finished look ......... especially the front end of the foregrip ....... Sorry, only registered users may post in this forum.
|