SPONSORS
2024 ICRBE EXPO |
source for large diameter rubberized cork
Posted by:
Steve Perakis
(---.hsd1.or.comcast.net)
Date: April 23, 2007 11:55PM
I am having difficulty locating unbored rubberized cork rings at 1 3/8" - 1 1/2" diameter, 0.5" wide. Everything I am finding is bored and/or too small. Most places seem to carry the 1 1/4" stuff.
I'd appreciate a solid lead - only 10-20 pieces are needed. Re: source for large diameter rubberized cork
Posted by:
Billy Broderick
(---.hsd1.fl.comcast.net)
Date: April 24, 2007 12:08AM
try @#$%& i bought a ton very cheap there and some with the plugs for them drilled had them for a couple of years now though so don't know if they are still there Re: source for large diameter rubberized cork
Posted by:
Billy Broderick
(---.hsd1.fl.comcast.net)
Date: April 24, 2007 12:08AM
try @#$%& i bought a ton very cheap there and some with the plugs for them drilled had them for a couple of years now though so don't know if they are still there Re: source for large diameter rubberized cork
Posted by:
Steve Perakis
(---.hsd1.or.comcast.net)
Date: April 24, 2007 01:16AM
I bought some years ago from a site sponsor. I am looking again, now, and having trouble finding them. Thanks for the reply. Re: source for large diameter rubberized cork
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: April 24, 2007 10:39AM
The rings from Angler's Workshop have always been 1 3/8 inch. Re: source for large diameter rubberized cork
Posted by:
Steve Perakis
(---.hsd1.or.comcast.net)
Date: April 24, 2007 10:56AM
the last batch that I purchased there was 1 1/4". More important, I stopped in 2 weeks ago, and they were completely out with no ETA Re: source for large diameter rubberized cork
Posted by:
Skipp Hughes
(---.neo.res.rr.com)
Date: April 24, 2007 06:14PM
There are some on @#$%& 1 1/2 x 1/2
Shoot me an email I'll send you the Link Re: source for large diameter rubberized cork
Posted by:
Paul_Schendel
(12.19.106.---)
Date: April 24, 2007 09:44PM
I make all my own rubberized cork rings by using rubberized sheet gasket material. Although it takes a little more work, I have the flexibility to make whatever OD and thickness ring I want. Just cut out the circles and glue together. I use a sharpened piece of pipe to make the circles. Re: source for large diameter rubberized cork
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: April 25, 2007 08:34PM
Steve,
Guess they changed recently at Angler's My last batch was still 1 /38 for rubberized, everythingn else has always been 1 1/4 inch. They had the 1 3/8 rubberized to match the big dia STBG8 preformed cork grip they sell I was told before. Sorry, only registered users may post in this forum.
|