SPONSORS
2024 ICRBE EXPO |
Looking for skeleton seat
Posted by:
Aaron Anderson
(---.proxy.aol.com)
Date: March 08, 2007 03:06PM
Hey guys, I have a customer that wants a handle and seat put on just like the G-Loomis mossyback series of spinning rods. Does anyone know where I could get that special skeleton seat that they use. I tried making everything with a regular skeleton seat but it didnt turn out the way I wanted. I wonder if its just me or the flat loomis seat makes the difference. Any help or thoughts would be appreciated. Aaron Anderson Beaver Rods Re: Looking for skeleton seat
Posted by:
Mark Blabaum
(---.dsl.mhtc.net)
Date: March 08, 2007 05:07PM
Mud hole has some that would fit the bill. I think to make the GLoomis syle all you would have to do is turn the insert around.
[shop.mudhole.com] Re: Looking for skeleton seat
Posted by:
Aaron Anderson
(---.proxy.aol.com)
Date: March 08, 2007 10:00PM
Thanks that is what I'm looking for. I wish I could just buy the seat though. Aaron Anderson Beaver Rods Re: Looking for skeleton seat
Posted by:
Kyle Olsen
(---.hsd1.or.comcast.net)
Date: March 08, 2007 11:19PM
They do carry just the seats, they're located in the reel seat section, not with the handle kits. Re: Looking for skeleton seat
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: March 09, 2007 06:52PM
Hopefully Loomis will now go back to using the whole stinger seat, they ran out of the threaded section some time ago and been using Fuji threads which aren't near black enough to match. Re: Looking for skeleton seat
Posted by:
Aaron Anderson
(---.proxy.aol.com)
Date: March 10, 2007 11:54PM
Thanks Everyone! Aaron Anderson Beaver Rods Sorry, only registered users may post in this forum.
|