SPONSORS
2024 ICRBE EXPO |
dan Craft FRSV997-3 guide spacing
Posted by:
Mark Waring
(---.server.ntli.net)
Date: February 27, 2007 03:37PM
Has anyone built a Dan Craft Five Rivers Signature 997-3 and got a good set of guide spacings? I am not very good at positioning rings myself, and the detail I can get elswhere seems rather generic (ie 10' 3 piece rod) Also, would you vary the spacings between Sic and recoils, or are they the same. I am leaning towards the lightweight titanium fujis. the other question I have got is - 16mm or 12mm first stripper?
Any advice greatly received thanks mark Re: dan Craft FRSV997-3 guide spacing
Posted by:
eric zamora
(---.dsl.frsn02.pacbell.net)
Date: February 27, 2007 04:48PM
if you don't want to read up on and learn guide placement, i'd contact dan who probably had some strong input on the design of that blank.
eric fresno, ca. Re: dan Craft FRSV997-3 guide spacing
Posted by:
Mike Barkley
(---.try.wideopenwest.com)
Date: February 27, 2007 05:10PM
Dan will give you his recommendations. Mike (Southgate, MI) If I don't want to, I don't have to and nobody can make me (except my wife) cuz I'm RETIRED!! Re: dan Craft FRSV997-3 guide spacing
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: February 28, 2007 12:34AM
By the way, you picked an awesome blank to work with. Mine is only slightly off an's recommendation. Won't be home for a few days or I'd tell you what mine was. Sorry, only registered users may post in this forum.
|