SPONSORS
2024 ICRBE EXPO |
Bearings on Pac Bay thread carriage
Posted by:
Scott Parsons
(205.244.119.---)
Date: February 01, 2007 01:04PM
Does anyone have any idea as to where I might source the bearings for the underside of the Pac Bay Wrapper thread carriage. I just reciently built a new carriage to hold madeira thread and could a couple extra bearings on the underside. Check out the pics of it. Thanks Scott Re: Bearings on Pac Bay thread carriage
Posted by:
Spencer Phipps
(65.197.242.---)
Date: February 01, 2007 02:28PM
Scott,
I know you can get them from Angler's Workshop as it's the same stuff on the Custom Power Wrapper carriage. Re: Bearings on Pac Bay thread carriage
Posted by:
Gregory Martin
(---.proxy.aol.com)
Date: February 01, 2007 06:11PM
I bought some 2 years ago direct from PacBay because there was no supllier in my area. E-mail them and see if they'll still do that.
Greg Re: Bearings on Pac Bay thread carriage
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: February 01, 2007 08:03PM
If you are looking for ball bearings, you can get replacement bearings at any good bearing supply house.
Take the old bearing in, they will measure it, and will supply a replacment bearing. Take care Roger Sorry, only registered users may post in this forum.
|