SPONSORS
2024 ICRBE EXPO |
lathe from bench top drill press
Posted by:
Billy Broderick
(---.hsd1.fl.comcast.net)
Date: April 30, 2006 01:21AM
does anyone have tips, plans or experience in making a cork lathe out of a bench top drill press? I really want to make one out of my table top drill press. I envission some how a horizontal set up. I don't even know what speed I should use as my press is variable speed depending on the belt used and its configuration. Thanks for your time one and all!!! Billy billy B-Rod custom rod building and rod repair located in Naples Marco Island Florida Re: lathe from bench top drill press
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: April 30, 2006 01:47AM
Billy, here's a pic of one from Penn State [www.rodbuilding.org] Mike (Southgate, MI) If I don't want to, I don't have to and nobody can make me (except my wife) cuz I'm RETIRED!! Edited 1 time(s). Last edit at 04/30/2006 01:48AM by Mike Barkley. Re: lathe from bench top drill press
Posted by:
Anonymous User
(Moderator)
Date: April 30, 2006 07:26AM
RodMaker Volume 6 #2 has the plans and directions for use.
............. Sorry, only registered users may post in this forum.
|