SPONSORS
2024 ICRBE EXPO |
reamer abrasive
Posted by:
Mark Gallihugh
(---.proxy.aol.com)
Date: March 16, 2006 02:33PM
I found some 1 inch non- skid strips for steps and ramps with a good adhesive at the hardware.Bought 5ft for 3 bucks went home and cut them in 1/4in strips .I already hade the handle ready to go .Pealed the backing off and wrapped them around and made 7 in just a few minutes .No epoxy needed.Been using them for weeks there still in real good condition .
Mark Re: reamer abrasive
Posted by:
Larry Thomas
(---.dfw.dsl-w.verizon.net)
Date: March 16, 2006 06:10PM
I did too. However, when the reaming gets tough the grit comes right off. It can't take the pressure or heat.
I use narrow sanding belts and contact cement. Re: reamer abrasive
Posted by:
Billy Vivona
(67.72.26.---)
Date: March 16, 2006 06:12PM
FC Reamer Abrasive Re: reamer abrasive
Posted by:
bill boettcher
(---.250.150.89.Dial1.Weehawken1.Level3.net)
Date: March 17, 2006 10:28AM
This stuff works great and does not come off [shop.mudhole.com] Re: reamer abrasive
Posted by:
Andrew White
(---.ks.ks.cox.net)
Date: March 17, 2006 06:59PM
I made just three reamers with the Flex Coat Reamer abrasive belt a few years ago, and those three have served my power reaming needs ever since. I used devcon epoxy to epoxy the abrasive belt on an old piece of fishing rod, and some golf club shanks, etc. Then, I epoxied some old drill bits into the butt end. That way, they chuck into my lathe really well, and I can ream my cork pieces in no time at all. It took a little bit of time to make them, but the pay off is incredible. The only problem is that they work almost too well. I have to really watch and make sure I don't over-ream. Sorry, only registered users may post in this forum.
|