SPONSORS
2024 ICRBE EXPO |
Photo request
Posted by:
Ken Preston
(---.hsd1.md.comcast.net)
Date: March 04, 2006 05:20PM
Could someone post a photo of the Renzetti spring arm / thread assembly? I think I put it together correctly but I'm not positive. The configuration of the black metal pin and how the spring tension arm is the piece I'm a little conerned about. Re: Photo request
Posted by:
Randy Parpart (Putter)
(---.propel.com)
Date: March 04, 2006 07:04PM
Oh. Thought you might want an update on Osama or somethin'... Putter Williston, ND Re: Photo request
Posted by:
Dennis Papike
(---.broadband.oakhurst.st)
Date: March 04, 2006 07:13PM
Hey Ken , I posted a pic, I think that's what you wanted to see. Re: Photo request
Posted by:
Ken Preston
(---.hsd1.md.comcast.net)
Date: March 04, 2006 11:48PM
Thanks Dennis! I put the wire spring on the left side because that's where the black pin was protruding. There was nothing on the right to hold the wire up (kept falling down to the base of the thread carriage. I think I'll be ok. If not I'll reverse it back. Thanks again most appreciated Sorry, only registered users may post in this forum.
|