SPONSORS
2024 ICRBE EXPO |
20# spiral rod
Posted by:
Barry Podmore
(---.cablenett.net)
Date: February 27, 2006 07:07AM
was planning on using ring guides all the way with a roller tip.. what u think?
unsure on guide sizes was looking at 16, 12, 12, 10, 10 then tip.... too big? plan on using them for small billfish .. thanks again Re: 20# spiral rod
Posted by:
Mark Griffin
(---.lsanca.dsl-w.verizon.net)
Date: February 27, 2006 10:47AM
I've done the same set-up, but with a larger stripper, just because of the height of the reel. MAKE SURE YOU GET THE RIGHT TOP! All American's "@#$%&" tops are the only ones that will work "up side down". Sizing may be a little limited in your light application. They offer #9, #10, #11, #12, #14, #16 & #18. Mark Griffin [] C&M Custom Tackle San Dimas, California Edited 2 time(s). Last edit at 02/27/2006 01:32PM by Mark Griffin. Re: 20# spiral rod
Posted by:
Ralph D. Jones
(---.bhm.bellsouth.net)
Date: February 27, 2006 08:42PM
With a #16 for a butt guide I'd use 16, 12, 10's to the tip. This is assuming an 8 is too small & you need a 10 to pass the knots in your terminal rig. If an 8 is large enough, 16, 10, 8's to the tip. Ralph If at first you don't succeed, go fishing, then try, try again. Sorry, only registered users may post in this forum.
|