SPONSORS
2024 ICRBE EXPO |
Reaming Corks
Posted by:
Greg Plummer
(199.60.68.---)
Date: January 27, 2006 02:32PM
I am looking for some advice on how to spead up the cork reaming process. Currently I am using hand reaming techniques which is fine for fly rod grips but I am currently building salmon mooching rods and there is up to 30 corks per rod. Does anyone have any tricks or tools that they use to speed up the process? Re: Reaming Corks
Posted by:
Doug Moore
(---.dfw.dsl-w.verizon.net)
Date: January 27, 2006 02:53PM
Greg, you can speed up the reaming process by pre-drilling your rings to the smallest OD the grip will be adhered to, then finish reaming from there. Regards......Doug@ TCRds Re: Reaming Corks
Posted by:
Bret Rahe
(---.ch2m.com)
Date: January 27, 2006 02:54PM
I use a small drill press with a cone-shaped rasp (from Home Depot) bit to ream individual rings. Not the best to keep the hole perfectly centered, but, has worked well for me. Re: Reaming Corks
Posted by:
Greg Plummer
(199.60.68.---)
Date: January 27, 2006 02:55PM
Thanks for the advice, what type of drill bit are you using. I tried that and the bit chewed the cork apart. Also, how do you keep the center hole aligned when power reaming? Re: Reaming Corks
Posted by:
Steve Broadwell
(---.132.29.71.ip.alltel.net)
Date: January 27, 2006 03:27PM
I glue the rings up before reaming, and use a regular round file. Have a couple different sizes I bought from Walmart. Just be real sure to run the drill backwards, or the file is pulled into the cork and will cause a split. Re: Reaming Corks
Posted by:
David A. Fuller
(---.region6.ang.af.mil)
Date: January 27, 2006 03:59PM
Greg, see the short discussion I posted a few days ago here. It's currently on page two, down about half way, titled "Center drilling cork". The guys here gave some great ideas plus I got the photo of the devise used for center drilling cork disks...
good luck and hope you get them thangs reamed good. God Bless America Good Wrappin ! David A. Fuller, Great Basin Fishing Rods Full-Time RV'r Traveling- n- Fishing www.mytripjournal.com/FullersBigAdventure Re: Reaming Corks
Posted by:
Neal Cissel
(---.phnx.qwest.net)
Date: January 27, 2006 05:05PM
The best way to do a lot of cork ring with a cork reamer is make your cork reamers with solid glass blanks then chuck them into your drill press or wrapping machine and ream out the rings or cork grips. The reason you use solid glass blanks is they won't crack when you torque them down on the drill press or wrapping machine chuck. It is really fast and smooth and the holes are perfect.
Neal's Fishing Products Re: Reaming Corks
Posted by:
bill boettcher
(---.250.195.202.Dial1.Weehawken1.Level3.net)
Date: January 28, 2006 09:23AM
You can also put the reamer in a hand drill Sorry, only registered users may post in this forum.
|