SPONSORS
2024 ICRBE EXPO |
Dan Craft FT 904 Guide Spacing
Posted by:
Bennett Pyles
(---.st.northropgrumman.com)
Date: December 09, 2005 12:49PM
I am building a new rod using a Dan Craft FT 904 blank. The blank is a 9', 4 weight, 4 piece blank. I was wondering if anyone could make a recommendation on guide spacing?
Thanks, Bennett Re: Dan Craft FT 904 Guide Spacing
Posted by:
Anonymous User
(Moderator)
Date: December 09, 2005 02:20PM
Either use the method listed on the library page here for static guide placement, or contact Dan for a generic recommendation for his blank.
There are also generic guide placement charts on the St. Croix site. They should get you started. ............... Sorry, only registered users may post in this forum.
|