SPONSORS
2024 ICRBE EXPO |
Jesse`s Seat Replacement Method
Posted by:
Fred Yarmolowicz
(66.252.177.---)
Date: November 29, 2005 04:44PM
I just cut a seat in half to remove it by peeling away.I am going to use Jesse Buky`s method to splice the rod bac together.Question is:The handle was extended with alluminum pipe that has no taper.Could i use a hardwood dowl to splice the handle together or a piece of blank shimmed with drywall mesh?? Freddwhy (Rapt-Ryte) Re: Jesse`s Seat Replacement Method
Posted by:
Sammy Mickel
(64.53.8.---)
Date: November 29, 2005 05:31PM
Find a peice of Alunimum pipe that fits the inside diamater, prep both peices good and put it back together. Re: Jesse`s Seat Replacement Method
Posted by:
Fred Yarmolowicz
(---.brick101.nj.comcast.net)
Date: November 29, 2005 10:33PM
Sammy,did as you suggested and glued her up today.Thanks. Freddwhy (Rapt-Ryte) Re: Jesse`s Seat Replacement Method
Posted by:
Jesse Buky
(---.exis.net)
Date: November 30, 2005 09:59AM
Once you get over the phobia of cutting your rod in half this is a very easy and quick repair method. I learned it back in 88/89 at this tackle shop where they got a lot of repairs on really cheap rods. Jesse Re: Jesse`s Seat Replacement Method
Posted by:
Fred Yarmolowicz
(---.brick101.nj.comcast.net)
Date: November 30, 2005 06:03PM
Its not my rod so the phobia dont apply lol. Freddwhy (Rapt-Ryte) Sorry, only registered users may post in this forum.
|