SPONSORS
2024 ICRBE EXPO |
Easy way to put a label on fly rod & rod case
Posted by:
Bailey Sory
(64.142.73.---)
Date: November 22, 2005 07:46PM
I am seeking advice on the easiest way to put the rod information on the blank. For example: 9' 7wt 5pc built by: XXX
Also what is the easiest way to afix the same information onto an aluminum tube. I am building a few rods as Xmas presents and would like to afix the info on the rod and the case and I have't done this before and am looking for a simple solution. Many thanks in advance. All the best, Bailey Re: Easy way to put a label on fly rod & rod case
Posted by:
bill boettcher
(---.an2.nyc41.da.uu.net)
Date: November 22, 2005 08:03PM
call Decal Connection. They should be able to help make any decals any size, for rod and tube Re: Easy way to put a label on fly rod & rod case
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: November 22, 2005 09:09PM
Decal Connection! Great service, good prices and fast delivery!!!
Mike Re: Easy way to put a label on fly rod & rod case
Posted by:
Domenic Federico
(---.dsl.bcvloh.ameritech.net)
Date: November 23, 2005 10:50AM
I'll third that! Decal Connection. They have my rod labeling business for life!
Domenic Federico Infinity Rod Creations WIckliffe, Ohio Re: Easy way to put a label on fly rod & rod case
Posted by:
Domenic Federico
(---.dsl.bcvloh.ameritech.net)
Date: November 23, 2005 10:51AM
I'll third that! Decal Connection. They have my rod labeling business for life!
Domenic Federico Infinity Rod Creations WIckliffe, Ohio Re: Easy way to put a label on fly rod & rod case
Posted by:
dave potts
(---.dsl.stlsmo.swbell.net)
Date: November 23, 2005 10:56AM
Bailey,
One thing I did on a flyrod was to take the button that fits into the butt of the reel seat to a local jewerly store (before gluing it in) and having them engrave it with the rod length and weight. Obviously not enough room for info on maker and date but it was my rod so I didn't need that on it anyway. On a spinning rod I made last year I found an old cuff link and cut the tab off that goes into the shirt cuff and then had the rod specs engraved on it before epoxing it to the butt of the rod. Dave Re: Easy way to put a label on fly rod & rod case
Posted by:
Steve Wilson
(---.hsd1.mn.comcast.net)
Date: November 25, 2005 11:29AM
For rod decals I would use Decal Connection. For vinal decals to go on your rod tubes Decal Connection (or their sister company) can do it for you but I believe they have minimum charges which could get expensive for 1 or 2 rods. What I did was to have my Rod Tubes (fly rods) made by REC and then have them or a local jewlery shop engrave the end caps Sorry, only registered users may post in this forum.
|