SPONSORS
2024 ICRBE EXPO |
need
Posted by:
Bill Cohen
(---.pm3-3.phi-pt.pa.localnet.com)
Date: October 28, 2005 11:08AM
Broke the mid section of the blank RXF130 8/9 3section matte finish. Supplier is out of them.Would like to pick up just the mid section if possible if not would consider the whole blank.This is for a customer fixing is not an option. Re: need
Posted by:
Billy Vivona
(67.72.26.---)
Date: October 28, 2005 11:17AM
You should contact the Manufacturer direct. If it falls under the Warantee, I'm sur ehtey'll replace it. If not, I'm sure they'll need BOTH sections so they can make a new mid section so that it fits properly. I know St. Croix fits their multi-piece rods together for each blank specifically, as when I had one break they needed it back to fit it. Re: need
Posted by:
Bill Cohen
(---.dyn.sprint-hsd.net)
Date: October 28, 2005 09:34PM
manufacture is out of business. Re: need
Posted by:
Spencer Phipps
(---.lsil.com)
Date: October 29, 2005 09:32AM
Many manufacturers keep some blanks around even if discontinued for a few years to service their customers. I know Lamiglas does. Rainshadow may also but someone will pay for it if it's a Cascade blank from Mudhole. I got a replacement Cascade from Mudhole that broke in the spline finder. Did the customer have it over 90 days? Sorry, only registered users may post in this forum.
|