SPONSORS
2024 ICRBE EXPO |
Cork Drilling Jig
Posted by:
John Niebergall
(---.ptldor.fios.verizon.net)
Date: October 27, 2005 11:16PM
I am looking for a picture I think I saw awhile back on a jig for holding cork while drilling. Anyone know where I can find it?
Thanks. John Re: Cork Drilling Jig
Posted by:
Christian Brink
(---.dsl.aracnet.com)
Date: October 28, 2005 12:05AM
The orginal Andy Dear design was in Volume 1 #5 of RodMaker.
Several variations are in the Photo Section of this site under Equipment. Christian Edited 1 time(s). Last edit at 10/28/2005 12:06AM by Christian Brink. ..... Correction
Posted by:
Shawn Moore
(82.96.100.---)
Date: October 28, 2005 08:25AM
Actually I believe that was the original Tom Kirkman design which Andy later began producing. I made one and it works like a charm. Great help in the shop. Re: Cork Drilling Jig
Posted by:
Anonymous User
(Moderator)
Date: October 28, 2005 08:34AM
Plans were indeed in the volume 1 #5 issue. Andy may also still have a few of these available for sale. It's a great tool. I think there is a photo of one on the photo page under my name. It would be the first one I ever made and the one used for the photos in the original article. They're not hard to make and sure work well.
........... Re: Cork Drilling Jig
Posted by:
Andy Dear
(216.198.62.---)
Date: October 28, 2005 10:15AM
Ha...that was a Tom Kirkman design, not an Andy Dear design. Great tool!
Andy Re: Cork Drilling Jig
Posted by:
Christian Brink
(---.dsl.aracnet.com)
Date: October 28, 2005 02:47PM
You know it's hard telling you two apart :)
Christian Re: Cork Drilling Jig
Posted by:
Andy Dear
(---.stic.net)
Date: October 28, 2005 05:19PM
Really? I am the good looking one...Tom is the smart one.
Andy Re: Cork Drilling Jig
Posted by:
Anonymous User
(Moderator)
Date: October 28, 2005 08:34PM
I just put a photo of one up on the photo page here. Sorry I sent you a on a wild goose chase earlier.
........... Sorry, only registered users may post in this forum.
|