SPONSORS
2024 ICRBE EXPO |
Overly conservative static weight distribution
Posted by:
Bill Cohen
(---.dyn.sprint-hsd.net)
Date: October 15, 2005 09:08AM
I'm building a Dan Craft 8'6 3wt. 4 piece.On my first section I have 5 guides not including the tip top. Does anyone have any info. on this rod or has built it. I hope I'm not being overly conservative in my SWD. It just occurred to me , the lighter and flimsier the tip the more guides you have to put in that area. I will also call Dan C. on Monday. Re: Overly conservative static weight distribution
Posted by:
Jeff Shafer
(---.phil.east.verizon.net)
Date: October 15, 2005 09:25AM
Bill,
If you're talking about the FT blank, I came to the same conclusion and have five guides in the tip section. I used light wire snakes on mine and the lowest guide on the tip section is on the ferrule. Dan had provided me some generic spacing which I modified. The result was: 1 - 4.00" 2 - 8.75" 3 - 14.00" 4 - 19.50" 5 - 25.75" 6 - 33.00" 7 - 41.50" 8 - 50.75" 9 - 61.25" 10 - 73.50" All measurements are to the center of the guide. Hope this helps, Jeff Shafer Re: Overly conservative static weight distribution
Posted by:
Bill Cohen
(---.dyn.sprint-hsd.net)
Date: October 15, 2005 10:00AM
Jeff. does Dan recommend 5 guides with out the tip for the first section? Sorry it is the FT. Re: Overly conservative static weight distribution
Posted by:
Jeff Shafer
(---.phil.east.verizon.net)
Date: October 15, 2005 10:12AM
Bill,
I placed some of Dan's guide spacing in an email to you. Jeff Re: Overly conservative static weight distribution
Posted by:
Bill Cohen
(---.dyn.sprint-hsd.net)
Date: October 15, 2005 10:18AM
Thanks for your help Jeff. Re: Overly conservative static weight distribution
Posted by:
James Mello
(---.haydrian.com)
Date: October 17, 2005 07:06PM
Just as another data point, I ended up with something very similar to you. On my 8wt I ended up with most of my guides on the front section.... Sorry, only registered users may post in this forum.
|