SPONSORS
2024 ICRBE EXPO |
Guide size and spacing for a 10,6 foot,#6, 4pc.CTS-Blank
Posted by:
Alexander Schlager
(---.infotech.at)
Date: October 03, 2005 03:40PM
Hello,
I am in the process to build a CTS-Affinity Plus blank - 10,6 foot, #6, 4piece model. I know, that the best way to get good results for guide spacing and guide size is to do some test casting and a distribution test. But it would be nice to have a suggestion for the guide spacing and guide size to have a starting point where I can than optimize the process. Greetings from Austria. Alex Re: Guide size and spacing for a 10,6 foot,#6, 4pc.CTS-Blank
Posted by:
Scott Youschak
(---.143.217.50.nw.nuvox.net)
Date: October 04, 2005 09:49AM
Try this link to the St. Croix website and match your blank to a comparable St. Croix. Again this is only a starting point and you will need to do a distribution test.
[www.stcroixrods.com] Sorry, only registered users may post in this forum.
|