SPONSORS
2024 ICRBE EXPO |
Reel seat help!!
Posted by:
Daniel Rees
(---.lns3-c8.dsl.pol.co.uk)
Date: September 30, 2005 01:39PM
Just recieved my REC nickel silver seat with black ash insert along with my Dan Craft Sig V 905-3. The butt of the blank is a nice snug fit into the reel seat insert. Is this OK? Or should the hole be larger than the diameter of the blank so that arbors are made using masking tape etc. Will I be OK to glue the blank straight into the insert, as I dont really want to have to bore a bigger hole if possible.
I'll be using U-40 Rod Bond if that makes a difference. Thanks Re: Reel seat help!!
Posted by:
Billy Vivona
(4.43.114.---)
Date: September 30, 2005 01:40PM
I think if it fits without forcing it on there, you are all set Re: Reel seat help!!
Posted by:
Stan Grace
(69.145.112.---)
Date: September 30, 2005 01:54PM
It only takes a very thin layer of rod bond to make the bond so I think your situation is perfect and always avoid masking tape arbors. Stan Grace Helena, MT "Our best is none too good" Re: Reel seat help!!
Posted by:
Daniel Rees
(---.lns3-c8.dsl.pol.co.uk)
Date: September 30, 2005 02:48PM
That's all I needed to hear.
Thanks fella's. Daniel Sorry, only registered users may post in this forum.
|