SPONSORS
2024 ICRBE EXPO |
Blue Nylon on White NCP....what if....
Posted by:
Joe Brava
(---.ms.com)
Date: September 29, 2005 01:00PM
Guys,
I have Navy Nylon on top of and White Underwrap. The underwrap is finished. I was thinking of finishing the Navy Guidewrap without using color preserver to preserve some of the translucence of the nylon. What do you think the results of not using CP on the Navy guidewrap will be? Thanks, Joe. Re: Blue Nylon on White NCP....what if....
Posted by:
bill boettcher
(---.250.171.11.Dial1.Weehawken1.Level3.net)
Date: September 29, 2005 01:07PM
Sounds like the white will lighten the navy. Blues do tend to stay dark.
Maybe the navy under the white?? Give the white a blue look?? No CP on the white Try it on some scrap Come to think about it, the last time I used a blue, I found it did not get that transparent as say the reds do. Edited 1 time(s). Last edit at 09/29/2005 01:20PM by bill boettcher. Re: Blue Nylon on White NCP....what if....
Posted by:
Jesse Buky
(---.exis.net)
Date: September 29, 2005 01:46PM
I use Gudebrod 245 Reg. [Royal Blue] for overwraps and Always Double Wrap to get a deep blue with no bleed through. A single wrap would give a bleed through. Needless to say I use no color perserver. Jesse Re: Blue Nylon on White NCP....what if....
Posted by:
Joe Brava
(---.ms.com)
Date: September 29, 2005 01:52PM
Another note that I should have mentioned....Gudebrod 050 Cobalt Blue and it is double wrapped! Re: Blue Nylon on White NCP....what if....
Posted by:
Lance Dupre
(---.sw.res.rr.com)
Date: September 29, 2005 02:25PM
cobalt blue double wraped will still look cobalt blue. It won't have that transparent look.
Lance Re: Blue Nylon on White NCP....what if....
Posted by:
Mark Griffin
(---.lsanca.dsl-w.verizon.net)
Date: September 30, 2005 01:11AM
050 on NCP white comes out NICE with Gudebrod CP. I've built quite a few for a guy in these colors over the years and even single overwraps come out SHARP. Lots more "pop" than with other CP's I've used on the same combo and the "luster" you mentioned is still there. Re: Blue Nylon on White NCP....what if....
Posted by:
Joe Brava
(---.ms.com)
Date: September 30, 2005 11:36AM
By means of follow-up on this thread I rolled the dice last night on my "patriot" Tuna Stick. The underwraps are fairly long white NCP. On either side they have Scarlet nylon trim bands. That was color preserved and epoxied. On top I put the guides and double wrapped with 050 Cobalt blue.
Finally I finished the whole thing with FlexCoat high-build epoxy. I was a little concerned that the guide wrap might suffer without CP but it really does look pretty cool IMOHO in a sort of retro-70's patriotic kind of way. I'll try and post some pictures. Thanks, Joe. Re: Blue Nylon on White NCP....what if....
Posted by:
Mike Naylor
(---.state.md.us)
Date: September 30, 2005 11:37AM
[www.rodbuilding.org]
Just to give you an idea how much of a difference it can make, check out the image I posted for you. Sorry for the poor image quality, but this is clipped from a much larger picture. I was playing around with some boxes weaves for a set of 9 trolling rods I rebuilt for a local charter captain. I did a base weave of NCP royal blue. Left to right you can see 1) NCP royal blue no epoxy 2) NCP royal blue with epoxy 3) plain boxes wrap without any epoxy (this turns into #5 after you apply epoxy) 4) what happens when you use only CP thread for everything 5) what happens when you use NCP royal blue underwrap and CP royal blue for the weave. I ended up doing all 9 with the weave on the right. The captain loved it. The combo of NCP and CP royal blue looked great. Re: Blue Nylon on White NCP....what if....
Posted by:
Mike Naylor
(---.state.md.us)
Date: September 30, 2005 11:39AM
Ack- go to the photo page under thread art to see the larger version... Sorry, only registered users may post in this forum.
|