SPONSORS
2024 ICRBE EXPO |
Flex Coat thin build over flex coat high build
Posted by:
Dan Nichols
(192.195.154.---)
Date: September 27, 2005 10:23AM
I have several finished rods that I want to put decals on. They were finished with flex coat high build.
I was intending to put the decals on a portion of the blank that is already finished, and then put another coat of flex coat over the top. Since the rods are already finished, I don't want to build up the flex coat too thick. Is it OK to put a layer of thin build on top of high build? Re: Flex Coat thin build over flex coat high build
Posted by:
bill boettcher
(---.250.156.21.Dial1.Weehawken1.Level3.net)
Date: September 27, 2005 10:30AM
Yes
Apply the decal, scoff " around " the decal for adhesion. Not under the decal or it will look foggy. A coat of CP over the decal will help to hold it down. Re: Flex Coat thin build over flex coat high build
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: September 27, 2005 05:55PM
That's fine, but you CAN put high build finishes on as thin as you want, also. Putter Williston, ND Re: Flex Coat thin build over flex coat high build
Posted by:
bill boettcher
(---.nyc.untd.com)
Date: September 27, 2005 10:57PM
This is also true. Re: Flex Coat thin build over flex coat high build
Posted by:
Mike Casey
(69.51.87.---)
Date: September 30, 2005 09:22AM
That is the way I build all my rods. I even use that method for putting the feather alignment marks at the ferrules. The second coat of lite FC Lite is sufficent to cover the feather and give me a smooth finish. As Bill suggested, I use a coat of CP (811) over the feathers before putting the FC Lite on. Sorry, only registered users may post in this forum.
|