SPONSORS
2024 ICRBE EXPO |
Fuji Plate Seat Dimensions
Posted by:
Mick McComesky
(---.245.81.2.Dial1.StLouis1.Level3.net)
Date: September 16, 2005 05:53PM
If anybody has a size 6 or 7 plate seat lying around, would you be kind enough to measure the width and height of it/them for me and the widest and tallest points (the hoods)?
An idea hit me today at work that I'd like to play around with over the weekend while I wait for an order to show up and the measurements would be a great help. Thanks much. Re: Fuji Plate Seat Dimensions
Posted by:
bill boettcher
(---.nyc.untd.com)
Date: September 17, 2005 08:12AM Mick Don't for get to show pictures ?? Re: Fuji Plate Seat Dimensions
Posted by:
Anonymous User
(Moderator)
Date: September 17, 2005 06:20PM
All I have is the Fuji catalog. It only lists length.
FS6 = 5&3/8" FS7SBW = 6&3/4" FS7BB = 5&3/4 ........... Re: Fuji Plate Seat Dimensions
Posted by:
Stan Massey
(---.cable.ubr04.uddi.blueyonder.co.uk)
Date: September 18, 2005 06:55AM
Mick,
got a plate seat here. Maximum length of seat is 5-3/4inch including a wrap over area for thread of 1/2inch each end . Width of actual plate is 7/8ths inch and hoods are 1/16th inch wider than that each side. Maximum movement of sliding hood is 2-7/8ths inch open to 1-1/2inch closed. (Measured to outside edge of hoods.) Height of sliding hood is 9/16ths at highest point and fixed hood is 1/2inch at highest point (both hoods have a slight down taper say 1/16th inch) Hope this helps, Stan. Re: Fuji Plate Seat Dimensions
Posted by:
Stan Massey
(---.cable.ubr04.uddi.blueyonder.co.uk)
Date: September 18, 2005 06:57AM
Mick,
in case you need to know for your experimenting, the sliding hood when raised to allow slide is then 1-1/8ths inch above lower edge of plate. Stan. Re: Fuji Plate Seat Dimensions
Posted by:
Mick McComesky
(---.245.86.19.Dial1.StLouis1.Level3.net)
Date: September 18, 2005 11:12AM
Outstanding, Stan. Thank you very much! Exactly what I was looking for. Sorry, only registered users may post in this forum.
|