SPONSORS
2024 ICRBE EXPO |
Nova Midi Lathe Chuck ????????
Posted by:
William Bartlett
(---.proxy.aol.com)
Date: September 08, 2005 10:47PM
Hi Guy's
Do any of you have a Nova Midilathe chuck? What size inserts do you use? it comes with a 50mm and that's way too big I bought the 25mm inserts when I bought the chuck but they're way too small. I need some advice here I was thinking 35mm would be just right. Bill in WV Re: Nova Midi Lathe Chuck ????????
Posted by:
Dave DeJong
(---.dialup.means.net)
Date: September 09, 2005 08:26AM
Hi
I don't have that particular chuck but heres a site that you can post that question. Its a wood turners forum. Members ther are very helpful. Dave [wmyoung.proboards23.com] Re: Nova Midi Lathe Chuck ????????
Posted by:
Curtis Beers
(---.225.204.68.cfl.res.rr.com)
Date: September 10, 2005 07:25PM
35MM spigot jaws will clamp like a pit bull. I use them for turning the wood handles for my offshore rods.
Curtis Re: Nova Midi Lathe Chuck ????????
Posted by:
Neil Toland
(---.dsl.louisacomm.net)
Date: September 11, 2005 09:49AM
William, once you figure this out I'd sure like to know what you come up with. I'm needing the same thing but am clueless as to what to get. Sorry, only registered users may post in this forum.
|