SPONSORS
2024 ICRBE EXPO |
Rod Decals
Posted by:
Tim Foster
(205.235.104.---)
Date: August 26, 2005 08:11PM
I recently bought a brother decal machine to make decals for my rods.The question is when I put the stickers on the rod every thing is fine until I put the rod finish over the decals the edges of the decal start to peel up.I would appreciate any ideas on how to correct this problem.
Thanks Re: Rod Decals
Posted by:
Lance Dupre
(---.sw.res.rr.com)
Date: August 26, 2005 08:39PM
Best remedy: buy your decals from Decal Connection. Re: Rod Decals
Posted by:
Jim Upton
(---.lsanca.dsl-w.verizon.net)
Date: August 26, 2005 09:53PM
Cover the Label with Color Preserver first . Re: Rod Decals
Posted by:
Emory Harry
(67.189.55.---)
Date: August 26, 2005 11:57PM
Tim,
There are good suggestions above but you might also consider putting a trim wrap on each end of the decal that just barely overlaps and holds down the four corners of the decal. Re: Rod Decals
Posted by:
Richard Popola
(---.carnival.com)
Date: August 29, 2005 01:28PM
Hi Tim,
I also use a Brother Labelmaker for my inscriptions and I coat the edges with "Hard As Nails". It takes a few minutes to dry and then I apply my finish. Rick Sorry, only registered users may post in this forum.
|