will permagloss work on the krylon fusion paint?
what size sponge are you using and how big a hole are you cutting in the sponge ?
have been using the spar urathane but the last rod i used it on i put a weave on it
and when i took the tape off it peeled the spar off with it. ( dont know what caused
this ) so i figure i will give the permagloss a try .
thanks for all and any input

david williams

If you do a search on this paint you will find that it takes 7 days for it to dry. One guy said it chipped very easy ? Permagloss may eat into it ? Try it after about a week.
I would suggest Duplicolor or Plasti-kote auto laquers.

I've never used a sponge to apply Permagloss. You can try it but I tend to think it won't work very well.

Permagloss has a "hot" solvent in it so it may blister or bubble some paints or finishes when applied over the top. If I want to recolor a blank, I tint the Permagloss and do it all in one step. Wish I could be of more help but I've never applied Permagloss over the top of another product. Perhaps someone else can advise you on this.

............

What I still wonder about -- is all the questions about permagloss being so HOT, why can's it be COOLED off ?? I have been using an auto two part clear, that does not have all the problems

David,

By sponge, you might be thinking of the method that Tom uses. A foam paint brush with either a tiny hole punched through it or a slit cut in it. It is dipped into Permagloss and the blank is passed through the hole or slit (or the brush is pulled down the blank)

Mike

you are right i did mean foam i just had sponge on the brain for some reason
i had let the krylon cure the full 7 days before spraying the spar so it was good and dry
the spar just didnt stick for what ever reason.

david williams